CLR 1796 / CLH 6580

UL 94-V0 system for potting and casting small electronic parts that require thermal shock and thermal cycling performance. A two component, low viscosity, room temperature cure epoxy system. Material has yellow card UL94-V0 rating, and contains non abrasive fillers suitable for meter mix dispense. CLR 1796 / CLH 6580

CLR 1876 / CLH 6631

Heat Cure low-stress, extremely tough, epoxy casting system casting system for large bushings, insulators, power and instrument transformers. Higher heat deflection temperature when compared to CLR 1331 / CLH 5515 family. Machine dispense friendly with excellent thermal stability and thermal cycling performance. The cured material exhibits excellent thermal stability and thermal cycling characteristics. This product meets UL94-HB flammability requirements. CLR 1876 / CLH 6631

CLR 3080 / CLH 6372

General Adhesive room temperature cure. Resistant to Toluene, Ethanol, Aviation Gas and Diesel Fuel. A low viscosity, two component, chemical resistant epoxy system. Post cured material has excellent resistance to most petroleum based fuels and solvents during exposure at ambient and elevated temperatures. CLR 3080 / CLH 6372

CLS 9600

High Temperature. A single component, 100% solids, low viscosity, impregnating compound for coils and transformers. This product is also suitable for sand casting. CLS 9600

XID 1681 / XHD 1652

A two component polyurethane casting system. Product has long pot-life and cures to a hardness of 65 Shore D. XID 1681 / XHD 1652

XRD 1014 / XHD 1015

High temperature clear epoxy. An unfilled, heat resistant, clear laminating system. Products low viscosity gives the system excellent wet-out properties to fibreglass and other reinforcing fibres. The material exhibits high physical strengths and modulus with moderate post cure temperatures. XRD 1014 / XHD 1015

XRD 1018 / XHD 1019

1:1 Mix Ratio, 130°C Operating, General Purpose, Low cost. A two component, room temperature cure semi-flexible, flame retardant, epoxy system. The system was developed for potting/casting of electrical and electronic components. Its use of non-abrasive fillers and convenient 1 to 1 ratio by volume, make it ideal for use in machine dispensing equipment. This product meets UL94-V0 in house flammability testing. XRD 1018 / XHD 1019

XRD 1321 / CLH 5185

Machine dispense friendly, tough, casting epoxy system. Increased flexibility when compared to CLR 1831 family. A two component, low stress, heat cure epoxy system specifically developed for use on instrument and power transformers. The product if filled with non-abrasive fillers, making the product suitable for machine dispensing. The cured material exhibits excellent thermal stability and thermal cycling endurance. Product meets UL 94-HB flammability requirements. XRD 1321 / CLH 5185

XRD 1347 / XHD 1348

The product cures to a shore hardness of 50 A, low viscosity, soft system. A two component, very flexible epoxy system. XRD 1347 / XHD 1348

XRD 1501 / CLH 6090

4:1 Ratio, soft system. A two component unfilled, flexible epoxy system. Product features low viscosity, long pot life and cures to a shore hardness of 70A. XRD 1501 / CLH 6090